Star Modem™ Setup For Stand Alone Mode - Datalogic Modem Quick Reference

DATALOGIC
Example
Command programming sequence:
$+
Each configuration parameter setting removes the condition previously active for that
parameter.
Refer to the STAR Modem™ Reference Manual for changing the default
parameters.
STAR Modem™ SETUP FOR STAND ALONE MODE
STAR Modem Receiver (Server)
RESTORE DEFAULT
Whenever necessary, send the following string to STAR Modem™ via RS232 to
restore its default values:
Restore STAR Modem™ Default
This command does not change the STAR Modem™ address nor the RF Baud
Rate parameters.
SET RADIO ADDRESS
Follow the procedure below to set the STAR Modem™ radio address and prepare it
to receive data from the RF devices of the system:
1.
Enter Configuration
2.
Set STAR Modem™ Radio Address
xxxx = four digits for the STAR Modem™ address (from
0000 to 1999). This address must be unique.
3.
Set RF Baud Rate (not for USA model)
x = 0 defines 9600 baud
1 defines 19200 baud
4.
Exit and Save Configuration
MA0RC1237 $-
STAR-Modem address in Stand Alone system: 1237
Enter configuration environment
CR
Carriage return character (0D Hex.)
Exit and Save configuration
UK/US
$+$*CR
$+
MA0RCxxxx
MFx
$-CR
7