Grizzly G0449 Owner's Manual page 43

8.
Measure the distance between the rear and
front drum, as shown in Figure 54, on both
sides.
Figure 54. Measuring distance between rear and
front drums.
— If the difference between the two measure-
ments at each end is equal or less than
", skip to Step 13.
⁄
1
8
— If the difference between the two measure-
ments at each end is more than
tinue to the next step.
9. Make two gauge blocks the same width as
your measurement in Step 8.
10. Place the small gauge blocks on each end
of the pressure roller between both drums as
shown in Figure 55.
Figure 55. Example of small gauge block
positioned between front and rear drums.
G0449/G0450 37" Drum Sander
11. Loosen the front drum pillow bearing lock
12. Slide the front drum against the gauge blocks
13. Now, go to Setting Rear Drum Height &
14. Tighten the front drum pillow bearing lock
⁄ ", con-
1
8
Gauge
Blocks
nuts (Figure 53).
until they are snug between the front and rear
drum. This will make the front drum parallel
to the rear drum—which is parallel to the rear
frame (conveyor rollers) and perpendicular to
the feed direction.
Adjusting Drums Parallel to Conveyor
Belt on Page 42.
nuts.
-41-