Power Connection - Grizzly G0449 Owner's Manual

To connect a dust collection hose:
1. Attach 4" dust collection hoses to the dust
ports shown in Figure 17 and secure them
with hose clamps.
Figure 17. Dust port locations.

Power Connection

Before connecting to power, read through the
SECTION 2: CIRCUIT REQUIREMENTS section
on Page 12 to check that your setup follows the
safety and circuit requirements for this machine.
Be sure to also have your electrician on hand for
the "Test Run" in case the power is connected out
of phase (Model G0450 only).
Attempting to connect this machine to the
power source without a qualified electrician
greatly increases the risk of electrocution,
fire, or machine damage.
To connect the sander to the power source:
1. Remove the screws securing the control
panel and lift off the face plate.
G0449/G0450 37" Drum Sander
2.
Feed the power wires through the strain relief
on the bottom of the control panel, tighten the
strain relief, connect the cord to the terminals
shown in Figure 18 or 19, and reinstall the
control panel face plate.
Note (Model G0450 Only): When using a
phase converter, connect the manufactured
power leg to the L1 terminal (Figure 19).
The L1 terminal can handle power fluctuation
because it is wired directly to the motor. The
other wires connect to the controls and must
be consistent to prevent damage.
Strain
Relief
Figure 18. G0449 control panel wiring.
Strain
Relief
Figure 19. G0450 control panel wiring.
3. Shut off the main power at the power source
circuit breaker and attach the wires to the
locking shutoff switch.
Ground
Ground
-19-