Gigabyte GA-VM900MC User Manual page 64

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup .
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Make sure that the SATA Controller under the Integrated Peripherals menu is enabled. To create
RAID, set SATA Controller Mode (Figure 1) to RAID (IDE by default). Set SATA Controller Mode
to IDE if you do not want to create RAID.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
SATA Controller
SATA Controller Mode
IDE DMA transfer access
OnChip IDE Channel0
OnChip IDE Channel1
IDE Prefetch Mode
Azalia HDA Controller
LAN Controller
USB 1.1 Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
Onboard LAN Boot ROM
Legacy USB storage detect
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x EPP Mode Select
: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
GA-VM900MC Motherboard
Integrated Peripherals
[Enabled]
[RAID]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
EPP1.7
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 64 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults