Gigabyte GA-N650SLI-DS4L User Manual page 20

B. Setting the SLI Configuration Jumpers:
The SLI configuration jumpers are set to Normal Mode operation by factory default, so the first step is
to change the jumpers settings from Normal Mode to SLI Mode.
C. Connecting Two Graphics Cards:
GA-N650SLI-DS4L Motherboard
Step 1:
Move all the jumper caps from their default positions (pins 2-3) to
pins 1-2, including the JP1 jumper.
Step 2:
The finished SLI jumper configurations are shown in the
photo to the left. All the jumper caps have been moved to pins
1-2.
Step 1:
Observe the steps in "1-5 Installing an Expansion Card" and
install two SLI-ready graphics cards of the same model on the
PCIE_16_1 and PCIE_16_2 slots.
Step 2:
Insert the SLI bridge (the GC-DGBR2-RH) in the SLI gold
edge connectors on top of both cards. Make sure the two mini
female slots on the bridge connector securely fit onto the SLI gold
edge connetors of both cards.
Female slots on the bridge
connector
- 20 -
Gold edge connector on the top
of the graphics card