Gigabyte GA-N650SLI-DS4 User Manual page 76

After that, the Array List screen displaying the RAID array you created will appear (Figure 8).
(Note: BBS stands for BIOS Boot Specification. This indicates that the boot device is defined in the
BIOS.)
Boot
BBS
[Ctrl-X] Exit
To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure
9), where you should see detailed information about RAID mode, disk block size, disk model name,
and disk capacity, etc.
RAID Mode: Striping
Striping Width : 2
Port Index
1.1 0
1.0 1
[R] Rebuild
To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears,
press Y to confirm or N to cancel. Press ENTER to return to the Array List screen.
To exit the Nvidia RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen.
Now, you can proceed to install the SATA controller driver and operating system.
GA-N650SLI-DS4 Motherboard
MediaShield Utility Nov 2 2006
- Array List -
Status Vendor
Healthy NVIDIA
[ ] Select [B] Set Boot
Figure 8
Array 1: NVIDIA STRIPE 233.57G
- Array Detail -
Striping Block: 64K
Disk Model
ST3120026AS
ST3120026AS
[D] Delete [C] Clear Disk
Figure 9
- 76 -
Array Model Name
STRIPE 223.57G
[N] New Array [ENTER] Detail
Capacity
111.79GB
111.79GB
[ENTER] Return