F_Panel (Front Panel Jumper) - Gigabyte GA-K8N51GMF User Manual

8)

F_PANEL (Front Panel Jumper)

Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis front
panel to the F_PANEL connector according to the pin assignment below.
HD (IDE Hard Disk Active LED)
SPEAK (Speaker Connector)
RES (Reset Switch)
PW (Power Switch)
MSG(Message LED/Power/Sleep LED)
NC
9) F_AUDIO (Front Audio Panel Connector)
If you want to use Front Audio connector, you must remove 5-6, 9-10 Jumper.
In order to utilize the front audio header, your chassis must have front audio connector. Also please
make sure the pin assignments for the cable are the same as the pin assignments for the front audio
header. To find out if the chassis you are buying support front audio connector, please contact your
dealer. Please note, you can have the alternative of using front audio connector or of using rear audio
connector to play sound.
SPEAK-
Speaker Connector
SPEAK+
PW-
Power Switch
PW+
MSG-
Message LED/
MSG+
Power/
Sleep LED
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: Power
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal
Close: Reset Hardware System
Open: Normal
Close: Power On/Off
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
NC
Pin No.
1
2
10
9
3
4
1
2
5
6
7
8
9
10
- 21 -
20 19
NC
RES+
Reset Switch
RES-
HD-
IDE Hard Disk
HD+
Active LED
2 1
Definition
MIC
GND
MIC_BIAS
POWER
FrontAudio(R)
Rear Audio (R)/ Return R
NC
No Pin
FrontAudio (L)
Rear Audio (L)/ Return L
Hardware Installation