Gigabyte GA-EX58-UD4P User Manual page 32

10) GSATA2_0/1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, White)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller
supports RAID 0, RAID 1 and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for
instructions on configuring a RAID array.
A RAID 0 or RAID 1 configuration requires at least two hard drives.
11) PWR_LED (System Power LED Header)
This header can be used to connect a system power LED on the chassis to indicate system power
status. The LED is on when the system is operating. The LED keeps blinking when the system is
in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).
GA-EX58-UD4P Motherboard
GSATA2_1
7 1
7 1
GSATA2_0
1
- 32 -
Pin No.
1
2
3
4
5
6
7
Please connect the L-shaped end of the
SATA 3Gb/s cable to your SATA hard drive.
Pin No.
1
2
3
System Status LED
S0
S1
S3/S4/S5
Definition
GND
TXP
TXN
GND
RXN
RXP
GND
Definition
MPD+
MPD-
MPD-
On
Blinking
Off