Step 3: Install Expansion Cards - Gigabyte GA-8IG1000MF Series User Manual

The following tables include all memory-installed combination types:
(Please note that those types not in the tables will not boot up.)
Figure 1: Dual Channel Technology (DS: Double Side, SS: Single Side)
DIMM 1
2 memory modules DS/SS
X
4 memory modules DS/SS
Figure 2: Don't operate Dual Channel Technology (DS: Double Side, SS: Single Side)
DIMM 1
1 memory module DS/SS
X
2 memory modules DS/SS

Step 3: Install expansion cards

1. Read the related expansion card's instruction document before install the expansion card into the
computer.
2. Remove your computer's chassis cover, screws and slot bracket from the computer.
3. Press the expansion card firmly into expansion slot in motherboard.
4. Be sure the metal contacts on the card are indeed seated in the slot.
5. Replace the screw to secure the slot bracket of the expansion card.
6. Replace your computer's chassis cover.
7. Power on the computer, if necessary, setup BIOS utility of expansion card from BIOS.
8. Install related driver from the operating system.
AGP Card
When an AGP 2X (3.3V) card is installed the 2X_DET will light up, indicating a non-supported
graphics card is inserted. Informing users that system might not boot up normally due to
AGP 2X (3.3V) is not supported by the chipset.
GA-8IG1000MF Series Motherboard
DIMM 2 DIMM 3
X DS/SS
DS/SS X
DS/SS DS/SS
DIMM 2 DIMM 3
X X
X DS/SS
DS/SS X
Please carefully pull out the small white-drawable
bar at the end of the AGP slot when you try to
install/ Uninstall the AGP card. Please align the
AGP card to the onboard AGP slot and press firmly
down on the slot .Make sure your AGP card is
locked by the small white- drawable bar.
- 14 -
DIMM 4
X
DS/SS
DS/SS
DIMM 4
X
X
X