Step 3: Install Expansion Cards - Gigabyte GA-8ID2003 User Manual

Step 3: Install expansion cards

1. Read the related expansion card's instruction document before install the expansion card into the
computer.
2. Remove your computer's chassis cover, screws and slot bracket from the computer.
3. Press the expansion card firmly into expansion slot in motherboard.
4. Be sure the metal contacts on the card are indeed seated in the slot.
5. Replace the screw to secure the slot bracket of the expansion card.
6. Replace your computer's chassis cover.
7. Power on the computer, if necessary, setup BIOS utility of expansion card from BIOS.
8. Install related driver from the operating system.
AGP Card
When an AGP 2x (3.3V) card is installed the 2X_DET will light up, indicating a non-
supported graphics card is inserted. Informing users that system might not boot up normally
due to AGP 2x (3.3V) is not supported by the chipset.
GA-8ID2003 Motherboard
Please carefully pull out the small white-drawable
bar at the end of the AGP slot when you try to install
/ uninstall the AGP card. Please align the AGP
card to the onboard AGP slot and press firmly
down on the slot. Make sure your AGP card is
locked by the small white-drawable bar.
- 12 -