Set Up For Keyboard Linkage; Remote Control And Kayboard Operating Range - Gigabyte H663 User Manual

Set Up for Keyboard Linkage

1. Remove the cover and check if the batteries have been installed. (You can follow instructions on
P.10 Inserting the Keyboard Batteries).
2. Press connect button on the front panel. After pressing the button, its indicator will light (slowly)
and waiting for the match signal from RF Keyboard.
3. Then press this learning button on RF Keyboard to let receiver recognize signal. As soon as the
linkage is completed, the indicator turns to quick flash.
Remote Control and Keyboard Operating Range
The remote control uses infrared transmission to control the H663 / H663-RH. It is necessary to
point the remote directly at the H663 / H663-RH. Provided you are facing the H663 / H663-RH, the
remote will function well within a radius of about 3 meters (10 feet) and 30 degrees above or below
the H663 / H663-RH level. If the H663 / H663-RH does not respond to the remote control, move a
little closer or replace the batteries. The keyboard uses RF to control the H663 / H663-RH. It is not
necessary to point the keyboard directly at the H663 / H663-RH. Provided you are facing the H663
/ H663-RH, the keyboard will function well within a radius of about 10 meters without interference.
If the H663 / H663-RH does not respond to the remote control, move a little closer or replace the
batteries.
11
LED is bricking slowly
Press this button
Press this button