Rear Panel - TRENDnet TW100-BRV304 - Advanced VPN Firewall Router User Manual

Rear Panel

DMZ
Reset Button
WAN port
(10/100BaseT)
10/100BaseT
LAN connections
Power port
Figure 3: Rear Panel
Use a standard LAN cable to connect to a normal port on another
hub.
This button has two (2) functions:
•
Reboot. When pressed and released, the TW100-BRV304 will
reboot (restart).
•
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The TW100-BRV304 is now using the
factory default values.
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the TW100-BRV304 will automatically function
as an "Uplink" port when required. Just connect any port to a normal
port on the other hub, using a standard LAN cable.
Connect the supplied power adapter here.
Introduction
5