Gsm7252Ps Rear Panel - NETGEAR GSM7228PS-100NAS Hardware Installation Manual

Managed Stackable Switches GSM7200PS and GSM7300S Series Hardware Installation Guide
Table 1-3. GSM7252PS LED Description (Continued)
LED
ports
SFP+ Ports
(1 Link/ACT LED per
port)
Table 1-4. GSM7252PS Port PoE Power Specification
Port
1-8
9-48

GSM7252PS Rear Panel

The rear panel has two module bays, a redundant power supply connector, a console port,
and a power module bay for the APS525W.
Stacking/XFP/SFP+/CX4
Console
module bays
Figure 1-4 GSM7252PS Rear Panel
The module bays support any combination of the following:
• ProSafe 10-Gigabit Ethernet XFP Adapter (AX741)
• SFP+ Adapter AX743
• CX4 Adapter AX744
• ProSafe 24-Gigabit Stackable Module AX742.
For more information, see
Module Bays" on page 2-21.
10 | Chapter 1: Introduction
Description
•
Off: No SFP module link is established on the port.
•
Solid green: A valid 1000 Mbps SFP module link is established on the port.
•
Blinking green: The port is transmitting or receiving packets at 1000 Mbps.
•
Solid yellow: A valid 100 Mbps SFP module link is established on the port.
•
Blinking yellow: The port is transmitting or receiving packets at 100Mbps.
Note: If port 43~48 media is changed to copper, the SFP LEDs change to Off status.
• Off: No SFP module link is established on the port.
•
Solid green: A valid 10 Gbps SFP+ module link is established on the port.
•
Blinking green: The port is transmitting or receiving packets at 10Gbps.
Power Range
0w - 30w
0w - 15.4w
"Adapters and Modules Compatible with the High-Speed I/O
Power receptacle
Redundant
power supply
connector
Replaceable
power supply