Manually Assigning Network Parameters - NETGEAR GS748TNA Software User Manual

Manually Assigning Network Parameters

If your network has no DHCP service, you must assign a static IP address to your switch. If you
choose, you can assign a static IP address to the switch even if your network has DHCP service.
To manually assign a static IP address to your switch:
1. Connect the GS748T Smart Switch to your existing network.
2. Power on the switch by plugging in the power cord (Default IP is 192.168.0.239).
3. Install the Smartwizard Discovery Utility program on your computer
4. Start the Smartwizard Discovery utility.
5. Click Discover for the Smartwizard Discovery Utility to find your GS748T Smart Switch. You
should see a screen similar to that shown in
6. Click on Configuration Setting. A screen similar to that shown below appears.
Figure 2-3
7. Choose the Disable radio button for DHCP.
8. Enter your chosen switch IP address, gateway IP address and subnet mask, and then type your
password and click Set. Please ensure that your PC and the GS748T Smart Switch are in the
same subnet. Make a note of these settings for later use.
Using the Smartwizard Discovery Utility
Smart Switch Software User Manual GS748T
Figure 2-1 on page
v1.0, October 2007
2-1.
2-3