Page 1
LINCO UHF DIGIT L TR NSCEIVER J- 45-PMR Instruction Manual Thank you for purchasing your new linco transceiver. Please read this manual carefully before using the product to ensure full performance, and keep this manual for future reference as it contains information on after-sales service. In case addendum or errata sheets are included with this product, please read those materials and keep them together with this instruction manual for future reference.
Page 2
Introduction ■About IP54 rating / ust and splash resistant This product is pre-programmed in 3 zones with different PMR frequencies. The bout IP54 rating programming cannot be changed by the customer 5: Dust protected /Ingress of dust is not entirely prevented, but it must not enter in sufficient Please read this manual completely from the first page to the last, to learn all the quantity to interfere with the satisfactory operation of the equipment;...
Page 3
■Covering ranges You may expect a range of approx 3km (2 miles) located on a flat, Features noise-free place like on a beach. However, it may vary drastically depending on how to wear and ■ Output power 500 mW ERP carry the radios, surrounding locations/conditions and static noise levels (below or near power ■...
STAN AR ACCESSORIES BATTERY INFORMATION LINCO Standard ccessories Charging Operation The battery pack is not fully charged before delivery. Please read this chapter very carefully to understand about the battery pack and its charging instructions. Misuse may result in damaging you, and your property . ntenna Li-ion Battery Battery Charger...
BATTERY INFORMATION BATTERY INFORMATION LINCO (Caution) How to Charge • Risk of explosion, generation of heat or leak of chemicals inside if the battery is replaced by Charging should be conducted in a temperature range of 5°C to +40°C an incorrect type or reverse polarity. Use always the recommended types of batteries in this (+41°Fto +104°F).
PREPARATION BATEERY INFORMATION LINCO Attaching the Accessories How to Store the Battery Attaching/ etaching the Antenna • The best condition to store the battery pack is about 50% charged. Exausted or fully charged Attaching the Antenna: state my cause faster deterioration. Screw the antenna into the connector on the top of the transceiver by •...
Page 8
GETTING ACQUAINTE GETTING ACQUAINTE LINCO Part Name ntenna - Fixed to radio - Not detachable PTT key Press to transmit, release to receive. Side key - short press in analog mode is monitor . Long press switches zone1 to zone 3 Speaker Channel Knob Rotate the knob to select channel 1-16.
GETTING ACQUAINTE GETTING ACQUAINTE LINCO LE indication Part Name State Operation Microphone Transmitting External port Open the cover plate and connect the external speaker and microphone Green Receiving Belt Clip Flashes red Low battery Battery Latch Flashes green Channels are being scanned Flashes orange Digital call hang time and it will exit when the hang time is up Side Key...
BASIC OPERATION BASIC OPERATION LINCO In this manual the phrase "Press ** key" means to press it firmly and quickly release the Transmitting finger. Keep pressing the key may start different features. Press the PTT key. The red indicator turns on while transmitting. Power on/off the Radio While holding down the PTT key, speak into the mic at normal voice from the distance of 5cm (2 inches).
Page 11
FEATURES AND OPERATIONS FEATURES AN OPERATIONS LINCO TOT (time-out-timer) The TOT prohibits users from transmitting after a certain period of time has elapsed. The radio automatically returns to receive, and an alarm sounds. Press PTT key once to stop alarm. The PTT becomes active again when the Time-out penalty time is elapsed.
OPTIONAL ACCESSORIES TROUBLESHOOTING LINCO Problem Cause and Solution EBP-102: Battery (Li-ion 7.4V 2000mAh) E C-290: Charger . The battery is used up -charge the battery or change to a Failed to power E C-291: AC Adapter new battery. B. Possible hardware faulty. Contact your dealer. (220V) ERW-17: PC Cable EBC-52: Belt Clip .
SPECIFICATIONS SPECIFICATIONS LINCO General Transmitting Part DJ-D45-PMR: Frequency Range (TX/RX) 446,0-446,2MHZ RF Power Output 500 mW ERP (DJ-D45-PMR) Number of Channels 3 Zone / each 16 channels Current Drain (M X) <1.8 Zone capacity compliance Digital : 12.5kHz Spurious Emission Channel Spacing nalog : 12.5...
Need help?
Do you have a question about the DJ-D45-PMR and is the answer not in the manual?
Questions and answers