Casio PRIVIA PX-3S User Manual page 17

To use layer and split together
LOWER 1
LOWER 2
1.
Use the "Tone List" (page E-57) to look up the
group(s) and numbers of the tones (UPPER 1,
UPPER 2, LOWER 1, and LOWER 2 zone
tones) you want to use.
2.
Check to make sure that the both the
ct
(LAYER) and (SPLIT) button lamps are
unlit.
• If one or both lamps are lit, press the
ct (SPLIT) buttons to turn them off.
3.
4
Press the (UPPER 1) button so its lamp is
lit.
• This indicates you can select the UPPER 1 zone tone.
Lit
4.
Select the UPPER 1 zone tone.
• For details about selecting tones, see "To select a
tone" (page E-11).
5.
Press the cs (LAYER) button so its lamp is lit.
Lit
• This will cause the 5
light. This indicates you can select the UPPER 2 zone
tone.
6.
Select the UPPER 2 zone tone.
UPPER 1
UPPER 2
cs
cs (LAYER) and
Unlit Lit
(UPPER 2) button lamp to
7.
Press the cs (LAYER) button so its lamp is
unlit.
8.
Press the ct (SPLIT) button so its lamp is lit.
Lit
• This will cause the 2
light. This indicates you can select the LOWER 1 zone
tone.
9.
Select the LOWER 1 zone tone.
10.
cs
Press the (LAYER) button so its lamp is lit.
Lit
• This will cause the 3
light. This indicates you can select the LOWER 2 zone
tone.
11.
Select the LOWER 2 zone tone.
12.
Play something on the left and right sides of
the keyboard to confirm that the tones are
assigned and layered properly.
• You can change any of the zone tones at any time by
performing one of the operations shown below.
To change this
Do this:
zone's tone:
UPPER 1 zone Press the
then select a tone.
UPPER 2 zone Press the
then select a tone.
LOWER 1 zone Press the
then select a tone.
LOWER 2 zone Press the
then select a tone.
Selecting and Playing a Tone
Lit
(LOWER 1) button lamp to
Lit
(LOWER 2) button lamp to
4 (UPPER 1) button and
5 (UPPER 2) button and
2 (LOWER 1) button and
3 (LOWER 2) button and
E-15