Gateway FX6800 Reference Manual page 77

www.gateway.com
3
Disconnect any cables that are attached to any
expansion cards, noting their locations and orientation.
(You will reconnect the cables after you install the cards
on the new board.)
4
Remove the expansion cards by following the
instructions in
on page 68. You can slightly seesaw a card end-to-end
to loosen it, but do not bend a card sideways.
5
Remove the fan cover by squeezing the top (1) and
bottom (1), then pulling the cover (2) out.
"Adding or replacing an expansion card"
1
2
1
71