Charging Curve; Boost And Refresh In On Position - Cristec YPOWER+ Instruction Manual

To fine-tune charging, refer to the table in paragraph 3.3.1.1.
In the case of special batteries, please refer to a professional installer, who will make special adjustments in
accordance with the battery manufacturer's specifications and taking into account the particularities of the
installation.
CRISTEC declines all responsibility for damage to batteries or incorrect recharging.
C
3.6
HARGING CURVE
The charger's charge status is indicated by one of the green charge status LEDs

3.6.1 BOOST and REFRESH in ON position

With this setting, the
BOOST: BOOST, ABSORPTION, FLOATING + REFRESH, REBOOST.
V BOOST: BOOST voltage (see section 3.3.3.1)
V FLOAT: FLOATING voltage (see section 3.3.3.1: voltage with no BOOST)
T BOOST: BOOST maximum duration (see table above – paragraph 3.3.3.1)
T ABS: ABSORPTION maximum duration (see table above – paragraph 3.3.3.1)
BOOST phase:
Starts up automatically when the charger is turned on if the battery is flat. The current is then at maximum
output.
charger delivers a 5-step charge curve IUoU + automatic weekly recycling
42