General Information; Safety Instructions; Qualified Personnel; Intended U - Block ECONOMY SMART Manual

MANUAL EN
ELECTRONIC CIRCUIT BREAKER
V 1.08
BASIC SMART

2. GENERAL INFORMATION

2.1

Safety instructions

Please read these warnings and safety instructions carefully before operating the appliance. The de-
vice may only be installed by specialised and qualified personnel. In the event of malfunctions or da-
mage, switch off the supply voltage immediately and send the appliance to BLOCK Transformatoren-
Elektronik GmbH for inspection. The device does not contain any service parts. If an internal fuse blows,
there is most probably an internal defect in the appliance. The data provided are for product description
purposes only and are not to be regarded as warranted characteristics in the legal sense.
2.2

Qualified personnel

The product associated with this documentation may only be handled by qualified personnel in com-
pliance with the documentation associated with the respective task, in particular the safety instructions
and warnings contained therein. Qualified personnel can ensure, based on their training and experi-
ence, that the use of the described product fulfils all safety requirements as well as the applicable
provisions, regulations, standards and laws.
2.3

Intended u

This device is designed for installation in a housing and is suitable for use in general electronic devices,
such as industrial control systems, office equipment, communication devices or measuring devices. Do
not use this device in the control systems of aeroplanes, trains or nuclear facilities where a malfunction
could result in serious injury or danger to life.
2.4

Disclaimer

The contents of this publication have been checked with the utmost care to ensure that they corres-
pond to the hardware and software described. Nevertheless, there may be discrepancies between the
product and the documentation. Deviations may also occur due to the continuous further development
of the product.
For this reason, we cannot guarantee complete conformity. Should this documentation contain errors,
we reserve the right to make any necessary corrections without prior notice.
2.5

Installation

Installation must be carried out in accordance with local conditions, relevant regulations, national ac-
cident prevention regulations and the recognised rules of technology. This electrical equipment is a
component intended for installation in electrical systems or machines and fulfils the requirements of
the Low Voltage Directive (2014/35/EU). The required minimum distance to neighbouring parts must
be maintained in order not to impede cooling!
BLOCK Transformatoren-Elektronik GmbH
Max-Planck-Straße 36-46
27283 Verden Germany
•
Phone +49 4231 678-0
Fax +49 4231 678-177
•
info@block.eu
block.eu
•
29.08.2024 / FRAN
Subject to technical changes 4