Microphone Positioning - Nolangroup N-Com X Series Manual

1.3.

Microphone positioning

ONLY FOR X-1005 HELMETS
 With the help of the flat head tool supplied as standard equipment, open the microphone-holder
clip located on the right side of the helmet (Fig. 14-15).
 Position the microphone at the desired length, sliding the excess portion inside the cheek pad
lining (Fig. 16).
N.B.: To ensure good voice transmission quality, it is recommended to adjust the length of the
microphone so that the foam part is in front of your mouth.
 Close the clip. Make sure that the microphone side with the letter "n" is facing the inside of the
helmet (Fig. 17).
ONLY FOR X-903 HELMETS
 Hook up the specific microphone for full-face helmets in its seat in the chin guard (Fig. 18).
 Position the microphone wire in the vertical groove (Fig. 19) and afterwards behind the cheek pad
lining. If necessary, lift up the groove tabs and the cheek pad lining using a flat head tool (supplied
as standard equipment).
Fig. 14
Fig. 16
Fig. 18
Fig. 15
Fig. 17
Fig. 19
5