GKOLED GKOALG8 Series Installation Manual

PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
— To prevent personal injury or product damage only licensed electricians should install.
— To avoid electric shock or component damage, disconnect power before attempring installation or servicing.
— This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state, and local electric codes and safety standards.
— Disconnect product and allow cooling prior to servicing.
—
— This luminaire is designed to operate in ambient temperatures ranging from -40°F to 113°F and to be horizontally mounted with the LEDs facing down.
— This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the
hazards involved.
— MIN 167°F (75°C) SUPPLY CONDUCTORS
— CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR
— CAUTION - RISK OF FIRE
— When equipped with a Photocell,
— This product is not suitable for several special environments, such as places with corrosive gas liquids or high pressure water vapor.
Installation Guide
Square/Round Pole (Figure 1)
1. Loosen the four PM4*12mm screws and remove the side plate and rubber
gasket from the mounting bracket. Please skip to Step 3 if using a Square
Pole Mount.
2. If using the Round Pole Adaptor, place the adaptor between the arm and
the pole, with the radius side of adaptor towards pole.
"*1.97"
4. Feed the lead from the arm into the pole and make wiring connections
6. Inside the arm, make wiring connections between the lead from the
7. Reinstall the side plate and rubber gasket, tightening the screws. The
a tight seal around the edges.
Wall Mount (Figure 2)
mounting bracket.
2. Attach the back plate to the arm bracket using the KM4*10(mm) screws.
3. Use the provided plastic template to locate the places to drill the holes in the
4.
1. Loosen the two PM4*12(mm) screws and remove the side plate from the
mounting bracket.
2. Route the cord into the mounting bracket through the wiring hole, slide the
3.
4. Make wiring connections per the wiring diagram below.
pinch any leads.
®
LED AREA LIGHT
Round Pole
Adaptor
PM4*12(mm) Screws
KM4*10(mm)
Screws
onto
Back Plate
angle.
Series GKOALG8
Installation Guide
°.
"*1.97(inch)
UNC Bolts
PM4*12(mm)
Screws
Side Plate
Gasket
Open Tab
"*1.46(inch)
UNC Screws
Side Plate
PM4*12(mm)
Screws
OPEN
"*1.02(inch)
UNC Bolts
(Figure 1)
"*1.02(inch)
UNC Screws
GKO-V1-0924-US