Configuring The Router - Cisco 2691 - VPN Bundle Router Hardware Installation Manual

Chapter 3 Installing the Router
•
Note
If the
ROM monitor, see the router rebooting and ROM monitor information in the
Fundamentals Configuration Guide

Configuring the Router

You can configure your router by using one of the following tools:
•
•
•
Note
If you need help with interface and port numbering, see the
OL-2171-06
yourname con0 is now available
Press RETURN to get started.
If SDM is installed on your router, we recommend using SDM to perform the initial configuration.
For configuration procedures using SDM, refer to the quick start guide that shipped with your router.
You can also access the Cisco 2600 series routers quick start guides
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/26xx_qsg/index.htm
If you see the following messages, the router has booted and is ready for initial configuration using
the setup command facility or the command-line interface (CLI).
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
To learn how to use the setup command facility to configure the router, see the
Configuration Using the Setup Command Facility" section on page
CLI to configure the router, see the
section on page 3-28.
prompt appears, your system has booted in ROM monitor mode. For information on the
rommon 1>
Cisco Router and Security Device Manager. If your router was purchased with a virtual private
network (VPN) bundle, Cisco Router and Security Device Manager is installed on the router. See
the "Initial Configuration Using SDM" section on page 3-26
Setup command facility. you can use the setup command facility to prompt you for basic router
information. After the configuration file has been created, you can use the CLI or use
Cisco Router and Security Device Manager to perform additional configuration. See the
Configuration Using the Setup Command Facility" section on page
Command-line interface (CLI). If you prefer to use the Cisco IOS CLI, see the
Using the CLI (Manual Configuration)" section on page 3-28
"Initial Configuration Using the CLI (Manual Configuration)"
for your Cisco IOS software release.
"Interface Numbering" section on page
Cisco 2600 Series Routers Hardware Installation Guide

Configuring the Router

online at the following URL:
"Initial
3-26. To learn how to use the
Cisco IOS Configuration
3-26.
"Initial Configuration
for instructions on how to use the CLI.
"Initial
1-9.
3-25