Purpose - Cisco 2610XM Configuration

Purpose

Purpose of this document is to show how to use and configure Cisco 2600 Series
routers. Mainly this document has been done for Laboratory work course (S-38.133) at
Networking Laboratory at HUT. On laboratory course these Cisco's routers are used for
IPv4 routing in small network.
This document includes configuring interfaces up and routing part, which has manual
for RIP (Routing Information Protocol) and for OSPF (Open Shortest Path First). For
other routing protocols among others BGP (Border Gateway Protocol) see for example
1
Cisco's web site .
Chapter 3 is suited very good for example for PC routers running Zebra
3
Quagga ) as routing daemon, because it has same commands as Cisco routers use.
Mainly this document is collection of Cisco's manuals ([1] – [2], [6] – [7]), which are
modified for our laboratory course's use.
1
www.cisco.com
2
www.zebra.org
3
www.quagga.net
3
2
(nowadays