Opening The Chassis - Cisco 1760 - VPN Bundle Router Hardware Installation Manual

Appendix C Installing and Upgrading Memory and Packet Voice Data Modules

Opening the Chassis

Step 1
Step 2
Figure C-1 Removing the Cisco 1760 Chassis Screws
10 0- 24
0V ~
1. 5 M AX
/1 .5 A M
AX
50 -6 0
Hz
Step 3
Figure C-2 Removing the Top Cover of the Router
10 0- 24
0V ~
1.5 MA
X/ 1.5 A
MA X
50 -6 0
Hz
Pull the top cover
off in this direction.
78-13342-03
Follow these steps to open the chassis:
Make sure that the router is turned off and is disconnected from the power supply.
Use a flat-head screwdriver to remove the screws that hold the top and bottom of
the chassis together, as shown in
Some Cisco 1760 routers have five chassis screws in the rear assembly,
Note
but most models have three screws in the rear assembly.
Chassis
screw
Gently slide the top cover of the router toward you, as shown in
Cisco 1760 Modular Access Router Hardware Installation Guide
Figure C-1.
Opening the Chassis
Figure C-2.
C-3