Device Installation; Turning On The Companion Mini; Turning Off The Companion Mini - Alert-it Companion Mini Pro P176A User Manual

Device Installation

This handbook covers everything you need to know to install, test and maintain the Companion Mini.
The Companion Mini is designed to be fitted and used in 4 steps:
Step 1) Turn on the Companion Mini (see below).
Step 2) Turn on the Pager (see page 9).
Step 3) Fit the Reset Button (see page 10).
Step 4) Positioning and Testing (see page 11).
Step 5) Using the Companion Mini (see page 12).

Turning on the Companion Mini

The Companion Mini monitor is supplied with batteries
fitted but needs to be turned on before use.
To activate the Companion Mini, press and release the
recessed " " button on the front of the monitor using a
pen tip or similar tool [See figure 1].
The green light will illuminate briefly to indicate the unit
is turned on. The Companion Mini is now ready to be
positioned under the mattress.

Turning off the Companion Mini

If the Companion Mini is no longer needed it can be
turned off by press and holding the " " button for
8 seconds.
Release the button and the light will flash red rapidly for
several seconds upon shutting down.
The Companion Mini will send an "Monitor Off" fault
notification to the pager upon shutting down.
PLEASE NOTE:
After turning the Companion Mini off, any device
that it is paired with will now raise an "RF Fail"
alarm after 2 minutes. This is due to the devices no
longer receiving the regular radio Safelink signals
from the Companion Mini that they are expecting.
To stop the warning the mini will need to be
unpaired or deactivated on the pager.
8
Figure 1