Add a Device to an Existing Powerline Network
To add a device to a Powerline network with the default network password, all you need to do is plug
the new device into a power outlet.
If the network name has been set, then you will need to run the Powerline encryption utility to set the
new device to the network name. How you do this depends on whether the computer running the
Powerline encryption utility is connnected directly to the new Powerline device (local) or is connected
to a different device in the Powerline network (remote).
Adding a New Device from a Locally Connected Computer
1.
Plug the new Powerline device into an available AC power outlet and connect it to an Ethernet
port on the computer.
2.
Start the Powerline encryption utility and select the Security tab.
3.
Type the network name in the Private Network Name text box and click Set Local Device Only.
4.
Select the Main tab and check that the other devices in the Powerline network appear in the
device list. It may take a minute or two for all devices in the network to be detected.
Adding a New Device from a Remotely Connected Computer
1.
Note the device password given on the label on the back of the new Powerline device.
2.
Plug the new Powerline device into an AC power outlet.
3.
Start the Powerline encryption utility on the remote computer and select the Security tab.
4.
Click Use Default (Public Network). The password in the Private Network Password text box
changes to the default password, HomeAVPlug.
5.
Click Set All Devices.
6.
Select the Main tab and wait for the new Powerline device to be listed.
7.
Select the new Powerline device from the device list, and click Enter Password.
8.
In the pop‐up window, enter the password from the back label of the device and click OK.
9.
Select the Privacy tab.
10. Re‐enter the network name in the Private Network Name text box, and then click Set All
Devices.
Chapter 1 Installing the 200Mbps Powerline AV Adapter
13