Table of Contents
Related Manuals for Renkforce FT007TH
Summary of Contents for Renkforce FT007TH
- Page 1 FT007TH Thermo-Hygrometer Sensor User Manual 1 Introduction Thank you for your purchase of the FT007TH Thermo-Hygrometer Sensor. The following user guide provides step by step instructions for installation, operation and troubleshooting. 2. Thermo-Hygrometer Sensor.
- Page 2 1. Remove the battery door on the back of the sensor by removing the set screw, as shown in Figure 1 . Figure 1 2. BEFORE inserting the batteries, locate the dip switches on the inside cover of the lid of the transmitter.
- Page 3 Figure 2 3. Channel Number: The FT007TH supports up to eight Channels. To set each channel number (the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1. 4. Temperature Units of Measure: To change the transmitter display units of measure (°F vs.
-
Page 4: Sensor Operation Verification
(4) relative humidity 8. Close the battery door. Make sure the gasket (around the battery compartment) is properly seated in its trace prior to closing the door. Tighten the set screw. 3. Sensor Operation Verification Verify the indoor and outdoor humidity match closely with the console and sensor array in the same location (about 1.5 to 3m apart). -
Page 5: Glossary Of Terms
4. Metal Barriers. Radio frequency will not pass through metal barriers such as aluminum siding. If you have metal siding, align the remote and console through a window to get a clear line of sight. 6. Glossary of Terms Term Definition Accuracy Accuracy is defined as the ability of a measurement to match the actual... - Page 6 Problem Solution sensor assembly closer to the display console. If the sensor assembly is too close (less than 1 meter), move the sensor assembly away from the display console. Make sure the remote sensor LCD display is working and the transmitter light is flashing once per 60 seconds. Install a fresh set of batteries in the remote thermo-hygrometer.
Need help?
Do you have a question about the FT007TH and is the answer not in the manual?
Questions and answers