Troubleshooting - TRENDnet TPE-101I Quick Installation Manual

Troubleshooting

Q1: Why is the POWER LED off on the TPE-101I?
A1:
First, make sure the TPE-101I is connected into a power outlet. Second,
make sure that the PoE device is connected properly to the TPE-101I. Third, try
using another CAT-5 cable.
Q2: Why is the POWER LED off on the TPE-102S?
A2:
First, make sure that the TPE-102S is connected properly to the PoE switch or
TPE-101I (See 3.Hardware Installation). Second, try using another CAT-5 cable.
Q3: Will the TPE-101I work with any PoE device?
A3:
Any PoE device that follows the IEEE 802.3af standard will work with
TPE-101I.
Q4: Will the TPE-102S work with any non-PoE device?
A4:
Non-PoE devices such as access points will work with the TPE-102S only if
the non-PoE device operates at 5V, 7.5V, 9V or 12V.
Q5: I connected my non-PoE device into the TPE-102S, but my switch does not
recognize the device.
A5:
Power cycle the non-PoE device by either pulling out the power adapter
connector from the PoE injector or disconnecting the CAT 5 cable from the PoE
Out port. Reinsert the connection after 5-10 seconds have elapsed.
If you still encounter problems or have any questions regarding the PoE Injector/Splitter,
please contact TRENDnet's Technical Support Department.
6