The last port in the back of the unit is for the optional remote control.
remote access to the keyer menu if the main unit is out of reach.
connector through the back plate.
The remote control gives you
It is simply plugged into the
BASIC OPERATION
The Menu Driven Memory Keyer™ is simple to operate.
The push-button marked PWR controls power
to the unit.
After turning the unit on, the keyer will light the four LEDs sequentially and send the
characters "O" and "N" in Morse Code using the sidetone speaker.
This tells you the MFJ-492 is ready
for operation.
Start sending with the paddle.
Adjust the volume and speed to your preference.
If the speed is still too
fast or too slow, adjust the range of the speed knob using the Speed Set feature.
See Menu Operation.
Factory Reset
To reset the keyer to default settings, the MENU key is held down through power-up.
This resets all
settings to the factory default:
All memory messages are cleared.
Weight set to 50% duty cycle.
Iambic A mode selected.
Queue mode off.
Break mode off.
Output enabled.
If the keyer is turned on in the normal mode (without the MENU key held down), then the keyer will
retain all settings prior to power down.
Speed set to 20 WPM.
Sidetone frequency set to 2000 Hz.
MFJ MENU DRIVEN
Paeer
Wepre
te
F3
Furs
|
™
(eo) | ©) | @) | @ | ©)
MEMORY KEYER
Ey,
WwW 7
7
Yi
A
Save/Play | Save/Play
Save/Play | Save/Play
Serial
SPEED
VOLUME
Message 1 | Message 2 | Message 3 | Message 4 | _Number
anes
Decrement
Enter
Speed
Weight
Sidetone
Output
4 Paddle Z
Set
Set
Set
Tune
mman
pa
|
[sp
WT
HZ
TU
Semi-Auto
lambic
Queue
Sidetone
Output
On/Off
On/Off
On/Off
On/Off
On/Off
IA
Qu
[ ST
TX
lambic
|
Paddle
Hand
Random
AorB
Reverse
Key
Code
ak
oN
| Hk
ie
MODEL MFJ-492
MENU OPERATION
,
The MFJ-492 menu system consists of a menu button marked MENU,
five function buttons marked
F1-F5, and four menu LEDs marked A-D.
Pressing the MENU
key changes the menu level.
The
keyer will sound an audible key click and light the Menu LED of the new level.
The row of boxes
beside that LED now contains the functions of keys F1-FS.
For example,
to enable the Tune (key down) function, look for the box marked Output Tune on the
front panel.
It is found on Row B under the column FS.
Press the MENU key until the LED marked
B lights up. Then press the F5 key. The ae will respond by entering the Tune mode.
Squeeze the
paddles to exit that mode.
Page 2
Need help?
Do you have a question about the Menu Driven Memory Keyer MFJ-492 and is the answer not in the manual?