MFJ Menu Driven Memory Keyer -492 Instruction Manual page 8

mmand M mman n
W# Where #=0-9. Use word break to customize the length of the interword spacing. A standard
word break is 7 dot lengths long. The number following the W is the number of extra dot
lengths added to a word break. Keyer echos "OK" upon entry.
## ## = 00 - 09. Select one of the six character sets for the random code generation. Keyer echos
"OK" upon entry.
Invite
Speed Set ___(SP)
Use Speed Set (wpm) mode to change the speed of code. An alternating dot/dash is produced and the
speed is modified by using the paddles to increase/decrease speed. Squeeze paddles to exit.
Weigh Ww
Use Weight Set to modify the weight settings for code. An alternating dot/dash is produced and the
weight of the code is modified by using the paddles to increase/decrease weight. Squeeze paddles to
exit.
Sidetone Set (HZ)
Use Sidetone Set to change the sidetone speaker frequency. The paddles now change the tone of the
sidetone that is emitted from the speaker. This will not change the frequency of the code transmission
because the keyer does not affect the tone that a radio emits. Squeeze paddles to exit.
u Tun T
Use Output Tune to tune up your station. This sends a constant key to allow tuning of your station.
Squeeze paddles to exit.
MENU C
emi-A n/Off A
Use Semi-auto On/Off to toggle between semi-auto (bug) mode on and off. The keyer responds with
the current mode "ON" or "OFF". Semi-auto mode creates automatic dots but requires dashes to be
hand keyed. Note: Semi-Auto mode may not be used to enter messages, serial numbers or in
command mode.
lambic On/ I
Use Iambic On/Off to toggle between iambic modes on and off. The keyer responds with the current
mode "ON" or "OFF". Iambic mode allows you to squeeze both paddles and get alternating dashes or
dots. Non-iambic mode does not alternate between dots and dashes during a squeeze. It plays
whatever side made contact first until it is released. See Iambic A or B
Page 5