★
CAREFULLY READ THIS INSTRUCTION MANUAL AND THE INSTRUCTIONS OF THE
ASPIRATING PUMP PRIOR TO USING THIS PRODUCT.
★ DO NOT DISCARD THIS INSTRUCTION MANUAL UNTIL ALL THE TUBES IN THIS BOX ARE
USED UP.
1. PERFORMANCE:
Measuring Range
and Pump Stroke
Sampling Time
Colour Change
Detectable Limit
Operating Temperature
Aspirating Pump
1. THE DETECTOR TUBE CONTAINS CHEMICAL REAGENTS.
2. DO NOT TOUCH DIRECTLY THESE REAGENTS ONCE TUBES ARE BROKEN.
3. KEEP THE TUBES OUT OF THE REACH OF CHILDREN.
NOTICE
1
. USE ONLY WITH PUMP MODELS AP-20, AP-20S, AP-1 OR AP-1S.
OTHERWISE, CONSIDERABLE ERROR IN INDICATION MAY OCCUR.
2. BEFORE TESTING, CHECK THE ASPIRATING PUMP FOR LEAKS (
INSPECTION OF ASPIRATING PUMP)
SHOULD BE CORRECTED BEFORE USE.
3
. DO NOT USE THIS TUBE OUTSIDE THE STATED OPERATING TEMPERATURE RANGE.
4
. STORE TUBES IN A COOL AND DARK PLACE 0-25
EXPIRATION DATE PRINTED ON THE TOP OF THE BOX.
5
. PRIOR TO USE, CAREFULLY READ
6. READ THE CONCENTRATION IMMEDIATELY AFTER MEASUREMENT.
2. SAMPLING AND MEASUREMENT:
Break both ends of the detector tube.
①
CAUTION
②
Insert the detector tube into the aspirating pump securely as shown in Fig.1. Arrow mark shall point to
the pump.
)
Align the guide marks on the shaft and stopper of the aspirating pump.
③
Pull the pump handle at a full stroke until it locks and wait for 1.5 minutes or until the completion of sampling
④
is confirmed with the flow indicator of the pump. See descriptions about the flow indicator in the instruction
manual of the pump.
⑤
On completion of sampling, read the scale at the maximum point of the stained layer.
SPECIAL NOTE:
: 5 - 160 ppm
: 1 pump stroke
: 1.5 minutes
: White
→
Dark Brown
: 1 ppm
: 0 - 40
32 - 104 F
℃ (
: Model AP-20, AP-20S, AP-1 or AP-1S
SAFETY GLASSES AND GLOVES SHOULD BE WORN TO PREVENT
INJURY FROM SPLINTERING GLASS.
)
Ⅰ
. The scale is calibrated at 20
other circumstances should be corrected. (
AMBIENT CONDITIONS.
. When the maximum point of the stained layer is unclear or slanted, read the scale in
Ⅱ
the middle between the longest and shortest points.
INSTRUCTION MANUAL
ARSINE DETECTOR TUBE
°
No correction is necessary.
) (
CAUTION
. ANY PUMPS SHOWING SIGNS OF LEAKAGE
(
℃
ITEM 9 USER RESPONSIBILITY
Fig.1
(
℃ (
68 F , 50 %R.H. and 1013hPa. Readings obtained in
°
)
REFER TO ITEM 3. CORRECTION FOR
)
)
REFER TO ITEM 8.
/32-77 F , AND USE BEFORE
°
)
.
(
No.140SA
Need help?
Do you have a question about the 140SA and is the answer not in the manual?
Questions and answers