Configuring Vcs - TRENDnet TEW-435BRM User Manual

Wireless ADSL Router User Guide
PPPoE, PPPoA
IPoA
(IP over ATM)
5. Step through the Wizard until finished.
6. On the final screen of the Wizard, run the test and check that an Internet connection can be
established.
7. If the connection test fails:
•
Check all connections, and the front panel LEDs.
•
Check that you have entered all data correctly.

Configuring VCs

The Wireless ADSL Router supports multiple VCs (Virtual Circuits) on the ADSL connection.
VC1 must be used for general-purpose Internet access. The other VCs are available for special
purposes, such as Video-on-Demand.
You can only use these VCs if supported by your ISP and ADSL service provider. In that case,
they will provide the necessary configuration data.
Some ISP's allow multiple PPPoE connections. This allows
multiple PCs to connect to the Internet using PPPoE client
software. When using the Wireless ADSL Router, multiple
PPPoE connections are neither necessary nor supported.
To Configure additional VCs
1. Start the Setup Wizard again.
2. On the first screen, select VC2, and click "Next"
3. Configure the VC setup screen as described below, then click "Next".
You connect to the ISP only
when required. The IP address is
usually allocated automatically.
Normally, the connection is
"Always on".
a) User name and password are
always required.
b) If using a Static (Fixed) IP
address, you need the IP address
and related information (Network
Mask, Gateway IP address, and
DNS address)
IP Address allocated to you, and
related information, such as
Network Mask, Gateway IP
address, and DNS address.
14