Warning and Safety instructions
This washing machine is supplied with a special lamp to cope with
particular conditions (e.g. temperature, moisture, chemical
resistance, abrasion resistance and vibration). This lamp must only be
used for the purpose for which it is intended. The lamp is not suitable
for room lighting. Replacement lamps may only be fitted by a
qualified electrician or a Miele authorised technician.
Temporary or permanent operation with a self-sufficient or non-
mains synchronous energy supply system (e.g. isolated networks,
back-up systems) is possible. A requirement for the operation is that
the energy supply system complies with all current local and national
requirements that apply to stand-alone, solar and/or battery systems.
The protective measures provided in the building installation and in
this Miele product must also be assured in their function and
operation in isolated operation or in non-mains synchronous
operation, or replaced with equivalent measures in the installation.
For example, as described in the current publication of VDE-AR-E
2510-2.
The manufacturer's warranty will be invalidated if the appliance is
not repaired by a Miele approved service technician.
Correct use
The maximum load is 7.0 kg (dry laundry). See the "Programme
chart" for the maximum recommended loads for individual
programmes.
Do not install your washing machine in a room where there is a risk
of frost. Frozen hoses may burst or split, and the reliability of the
electronic control unit may be impaired at temperatures below
freezing point.
Before using the machine for the first time, check that the transit
bars at the rear of the washing machine have been removed (see
"Installation and connection – Removing the transit bars"). During
spinning, transit bars which are still in place can cause damage to
both the machine and adjacent furniture or appliances.
Turn off the tap if the machine is to be left for any length of time
(e.g. while on holiday), especially if there is no floor drain (gully) in the
immediate vicinity.
If the ventilation openings are in the base of the washing machine,
ensure that they are not obstructed by deep-pile carpet or similar.
10
Need help?
Do you have a question about the PWM 507 and is the answer not in the manual?