Table of Contents
Advertisement
XDVD8182
General Operation - Parking Brake Initialization
Parking Brake Initialization
PARKING BRAKE
HIGH / LOW state definition
High = OFF/NON-ACTIVE state
Low = ON / DEPRESS state
Note: The transition time must
be less than sec between
"High—Low"/"Low—High".
18
OPERATION
SAFETY WARNING
• The video display of the in-dash unit will not operate while the vehicle is
moving. This is a safety feature to prevent driver distraction. In-dash video
functions will only operate when vehicle is in Park and the PARKING BRAKE
is engaged. It is illegal in most states for the driver to view video while the
vehicle is in motion. Refer to local laws in your area.
• Audio can be heard while the monitor is closed.
• The vehicle must be in park and the parking brake applied to view video on the
in-dash monitor.
• As a safety feature, "ENGAGE PARKING BRAKE" blue screen will show on
the display when the vehicle's parking brake is not engaged. Video display
on the front monitor isn't allowed until the PARKING BRAKE is active. After
connecting the yellow/blue PARKING BRAKE wire to brake switch circuit as
described below, note however, DVD and AV1 audio can be heard while the
vehicle is in motion without engaging the parking brake.
Follow this two initialization procedure carefully to allow video playback:
There are usually two situations that start the PARKING BRAKE Sequence.
First situation is while driving:
1) Stop vehicle, put in Park, PARKING BRAKE off / non-active= "HIGH"
) Depress PARKING BRAKE for 1 sec = "Low"
3) Release PARKING BRAKE for 1 sec = "High"
4) Depress PARKING BRAKE hold permanently = "Low"
Note: The transform time must be less than sec between
"High—Low"/"Low High" to function properly
Once the High—Low—High—Low—HOLD procedure is complete approx 3
sec—video will display.
Second situation is while already parked and the PARKING BRAKE is already
engaged:
1) Keep vehicle in Park, PARKING BRAKE should be off = "Low"
) Release PARKING BRAKE for 1 sec = "High"
3) Depress PARKING BRAKE for 1 sec = "Low"
4) Release PARKING BRAKE for 1 sec = "High"
5) Depress PARKING BRAKE hold permanently = "Low"
Once the "Low" first: Low—High—Low—High—Low—HOLD procedure is
complete approx 5 sec—video will display.
Advertisement
Table of Contents
