Basic Operation; Checking The Sirius Signal Strength And Radio; Presetting Radio Stations (Preset Memory); Listening To Preset Stations - Denon AVR-789 Owner's Manual

Basic Operation

1
<SOURCE SELECT>
Either turn or press
to select "SIRIUS".
2
[SOURCE CONTROL 1]
Set to "AUDIO" and
CONTROL 2]
to "TUNER".
(vpage 61 "Remote Control Unit Operations")
3
TUNING
Use to select the station.
When the station is tuned in, the name of the track and artist
are displayed.
• The channel switches continuously when
held.
• SIRIUS Radio stations can be preset using the same procedure as
for FM/AM stations (vpage 51 "Presetting Radio Stations (Preset
Memory)" and "Listening to Preset Stations").
b You cannot perform "Auto Preset".
• The track name, artist name, composer name, category and reception
<STATUS>
level can be checked by pressing
• The time (default : 30 sec) for which the on-screen display are
displayed can be set at menu "Manual Setup" – "Option Setup"
– "On-Screen Display" (vpage 32).
Press uiop to return to the original screen.
Checking the SIRIUS Signal Strength
and Radio ID
[SAT TU1/2]
1
Either turn
to select "SIRIUS".
[SOURCE
2
<STATUS>
Press
display.
The display will switch as shown below, depending on the
reception conditions.
Display
EXCELLENT
GOOD
WEAK
TUNING
is pressed and
NO SIGNAL
3
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
4
<STATUS>
Press
.
(example: "SR001") is displayed.
5
TUNING
Press
Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID
************
b Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS and terrestrial signals can be checked
at menu "Input Setup" – "Antenna Aiming" (vpage 39).
<SOURCE SELECT> [SAT TU1/2]
or press
until "SIGNAL" appears on the
Status
Signal strength is excellent
Signal strength is good
Signal strength is weak
No signal
until the station you want to check
and select channel 0 (SR000).
Radio ID
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you can
tune them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2
[MEMORY]
Press .
3
SHIFT
Press to select the block (A to G) in which the
station is to be preset.
4
<PRESET> [CHANNEL +/–]
Press or
preset number (1 to 8).
5
[MEMORY]
Press again to complete the setting.
To preset other stations, repeat steps 1 to 5.
NOTE
Preset stations are erased by overwriting them.

Listening to Preset Stations

1
SHIFT
Press to select the memory block (A to G).
2
<PRESET> [CHANNEL +/–]
Press or
desired preset channel (1 to 8).
ENGLISH ENGLISH
to select the
to select the