Appendix A System Setup Program - Dell OptiPlex GXa Service Manual

Appendix A
System Setup Program
T
his appendix describes the System Setup program, which is used to change
the system configuration information stored in NVRAM on the system board.
To enter the System Setup program, follow these steps:
1. Turn on (or reboot) the system.
2. Press <Ctrl><Alt><Enter> immediately when prompted.
If you wait too long and the operating system begins to load into memory, let
the system complete the load operation; then shut down the system and try
again.
NOTE: To ensure an orderly system shutdown, consult the documentation that
accompanied the operating system.
System Setup Program A-1