Entering The System Setup Program - Dell Dimension 2400 Series Manual

Back to Contents Page
System Setup Program
Dell™ Dimension™ 2400 Series
Overview
Entering the System Setup Program
Clearing Forgotten Passwords
Overview
The system setup program contains the standard settings for your computer.
NOTICE: Unless you are an expert computer user, do not change the settings for this program. Certain changes might make your computer work
incorrectly.
You can use the system setup program as follows:
To change the system configuration information after you add, change, or remove any hardware in your computer
l
To set or change user-selectable options—for example, the user password
l
Dell recommends that you write down the system setup program screen information for future reference.

Entering the System Setup Program

1. Turn on (or restart) your computer.
2. When F2 = Setup, F12 = Boot Menu appears in the upper-right corner of the screen, press <F12>.
If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows® desktop. Then
computer and try again.
See the following figure for an example of the main program screen.
shut down your