Flash Furniture MT-M4824-WLT-ABF-GG Assembly Instructions

300LBS
ASSEMBLY INSTRUCTIONS
Before You Begin: A Phillips screwdriver or power screwdriver with magnetic drill bit and rubber
mallet required for assembly (Not Included). Item ships in 2 boxes, ensure you have received both
boxes before beginning assembly.
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD
- Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The tipping
restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
..................................................................................
MT-M4824-WLT-ABF-GG / MT-M4824-LTGRY-ABF-GG / MT-M4830-WLT-ABF-GG / MT-M4830-LTGRY-ABF-GG
MT-M6024-WLT-ABF-GG / MT-M6024-LTGRY-ABF-GG / MT-M6030-WLT-ABF-GG / MT-M6030-LTGRY-ABF-GG
MT-M7236-WLT-ABF-GG / MT-M7236-LTGRY-ABF-GG
Thank you for your purchase!
A-Frame
Conference Table