Cobra MRF80B Owner's Manual page 43

F80 Installation.qxp:QXP-1058720374.qxp
Introduction
Standby Mode
Channel Select Knob
Mic Channel Buttons
Channel 16/9 Button
WX/Enter Button
Tri-Watch Button
40 English
12/29/06
Getting Started
Standby and Receive
Standby mode is the usual mode for the radio whenever it is
turned On.
From Standby Mode, You Can:
I Change your radio's settings using setup routines.
I
Receive messages on the current channel as well as DSC
messages.
I
Receive NOAA alerts if Weather Alert mode is turned On.
I
Switch to Transmit mode using the Talk button.
While the radio is in Standby mode, the Receive mode is
entered whenever a strong enough signal to break squelch
is sent to the radio. You will hear the message through
whichever speakers are connected to the radio.
To Change the Channel You Are Listening to, You Can
Choose One of the Following:
1. Turn the Channel Select knob clockwise for higher VHF
channel. Turn the Channel Select knob counterclockwise
for lower VHF channel.
2. Press Channel Up/Down buttons on microphone to go to
the next higher or lower VHF channel. For rapid advance,
press and hold the Channel Up/Down button.
3. Press the Channel 16/9 button. This will take you to
Channel 16 with one (1) press and to Channel 9 with a
second press. Additional presses will toggle between
Channels 16, 9 and original channel.
4. Press the Weather/Enter button. This will allow you
access to the weather channels. Turning the Channel
Select knob or pressing the Channel button on the
microphone allows you to change weather channels.
5. Press the Tri-Watch button to monitor three (3) Channels
16, 9 and one user selectable channel.
10:03 AM Page 40