Clover CDR-1610 User Manual page 12

■ Power Cable Connection
Input the power after selecting power voltage of back side of system. Input voltage
tolerance is 10% and we can not warranty if you are using the over tolerance around
10%. If the electric system is not stable, please using the UPS or AVR.
Standard Input voltage: AC110V 50/60Hz or AC220V 50/60Hz
CAUTION: FACTORY DEFAULT SETTING IS AC110V 50/60Hz IN POWER
SELECT SWITCH. PLEASE DOUBLE CHECK BEFORE YOU INPUT
THE POWER INTO THE SYSTEM.
■ PAL / NTSC Selection
PAL or NTSC is set at the factory according to the country where the system is
shipped. If necessary, it can be reset as follows;
• Turn off the system, and then remove the cover.
• Reset the PAL/NTSC selection jumper (NTSC: open, PAL: close). Please refer
to Figure 4-1.
• Reassemble the cover.
• Turn on the system and format the HDD.
NOTE: WHEN THIS SETTING IS CHANGED, YOU WILL LOSE ALL OF YOUR
RECORDED DATA AND SETTINGS.
YOU SHOULD SET THE SYSTEM AGAIN AFTER THIS PROCEDURE.
Figure 1-10: Input power selection
- 12 -