Clover CDR-1610 User Manual page 10

■ Monitor Connection
1. Main Monitor
Connect the monitor to "Main" on the upper part of BNC connector.
2. S-VHS Monitor
Connect the S-VHS monitor to "S-VHS" DIN jack on the rear of the unit.
Output for S-VHS monitor is the same as that of main or auxiliary and has a
separate output buffer and works independently.
Figure 1-5: S-VHS Connector
3. VGA Monitor
Connect the VGA monitor to DSUB-15 Pin Connector on the rear of the unit.
Figure 1-6: VGA Connector
■ Sensor and Relay Connection
1. Sensor Alarm Input
Connect the sensor to ALARM-IN. The Sensor should be contactor type and
support NO (Normal Open).
2. Control Relay Output
The Output of RELAY-OUT is a relay contactor type and supports NO (Normal
Open), NC (Normal Close). The Output capacity is 220V 1A and a higher capacity
can cause system failure.
Figure 1-7: Sensor and Relay Connector
- 10 -