Download Print this page

Specifications; Troubleshooting Guide - Aiwa TP-M140 Operating Instructions

Aiwa microcassette recorder operating instructions

Advertisement

To clean the cabinet
Use a soft cloth ligtly moistened with a mild detergent solution. Do not use strong
solvents such as alcohol, benzine or thinner.

SPECIFICATIONS

Track system
Micro cassette, 2 tracks 1 channel, monaural
Usable tapes
Frequency response
250 – 5,000 Hz (2.4 cm/sec) EIAJ
Tape speed
2.4 cm/sec or 1.2 cm/sec switchable
Microphone
Electret condenser microphone (monaural)
Maximum output
170 mW (EIAJ/DC)
Output jack
EARPHONE jack (monaural mini-jack) (1)
Input jack
EXT MIC jack (monaural mini-jack)
Other jack
DC 3 V jack
Speaker
Diameter 36 mm, 4 ohms
Recording system
DC bias
Erasing system
Magnet erasure
Power sources
DC 3 V using two size AA (R6) batteries
AC house current using an optional AC adaptor Aiwa AC-D302
Maximum outside dimensions
63.8 (W)
122 (H)
(2
5
/
4
7
/
8
8
Weight
Approx. 116 g (4.1 oz) (excluding batteries)
Accesories
Microcassette tape MC-60 (1)
Size AA (LR6) dry cell batteries (2)
Specifications and external appearance are subject to change without notice.
COPYRIGHT
Please check the laws on copyright relating to recordings from discs, radio or
external tape for the country in which the machine is being used.

TROUBLESHOOTING GUIDE

If the unit does not perform as expected, check the following table.
Symptoms
Causes
Tape does not move.
• The batteries are not inserted correctly.
• The batteries are worn out.
• The unit is in pause mode.
Tape transport is unstable.
• There is slack in the tape.
• The pinch roller and capstan are dirty.
• The tape is damaged.
There is no sound.
• The VOL control is turned down completely.
• The earphone is not connected firmly when
listening with the earphone.
The sound is too low or
• The recording/playback head is dirty.
distorted.
• The batteries are worn out.
The playback speed is
• The TAPE SPEED switch is set to the wrong
not correct.
position.
Recording cannot be done.
• The erasure prevention tab on the recording
side of the cassette has been removed.
Tape stops during recording.
• Set the V-SENSOR switch to OFF when not
using the V-SENSOR function.
(Normal position type)
25.7 (D) mm
1
1
/
in)
16

Advertisement

loading