Clavia Nord Lead 3 Owner's Manual page 71

NORD LEAD 3 V1.2x
when in Dual Sine FM mode. The figure to the right of the dot in the LED D
of the semitone value of sine wave 2B, which is also the Modulator when in Dual Sine FM mode. The
sine wave 2B/Modulator partial value is relative to the pitch of Oscillator 1. In the pictures below, the
middle C (C4) note is our reference note. When you turn the C
crement or decrement the sine wave 2A/Carrier value in steps of 1 partial. When you turn the F
the LED D will increment or decrement the sine wave 2B/Modulator value in steps of 0.5 partials
ISPLAY
until it reaches the 10th or -10th partial. Beyond the 10th or -10th partial the increment/decrement is in
steps of 1 partial. The range for sine wave 2A/Carrier is 0 (-1 octave) to 9 partials in steps of 1 partial.
The range for sine wave 2B/Modulator is -16 to 94 partials in steps of 0.5 or 1 partial.
(Partials are multiples or divisions of a
fundamental pitch. Partial no. 2 is twice
the fundamental pitch and so on.)
D D D D 'KTB 'K 'K 'K TB TB
I I I I S S S S P P P P L L L L A A A A Y Y Y Y O O O O F F F F
When the KBT
OFF
The frequency value is displayed the same way for every waveform. In Dual Sine mode the frequency val-
ue pertains to sine wave 2A, which is also the Carrier when in Dual Sine FM mode. In the picture below,
the middle C (C4) note is our reference note. If you turn the C
decrement in steps of 1 semitone and the LED D
responding frequency in Hz. The range is 8.66 Hz to 12.5 kHz.
TB H H H H ' ' ' '
O O O O F F F F F F F F Z Z Z Z F F F F O O O O R R R R A A A A L L L L L L L L W W W W A A A A V V V V E E E E F F F F O O O O R R R R M M M M S S S S
H function is activated the LED D
Z
7. Panel reference: Oscillator 2
knob the LED D
OARSE
C
With the knob you control the sine
OARSE
wave 2A/Carrier partial value relative to the
pitch of Oscillator 1
F
With the knob you control the sine
INE
wave 2B/Modulator partial value relative to
the pitch of Oscillator 1
When the sine wave 2B/Modulator partial number is
within the range -9.5 to 9.5 partials, the dot to the
LED D
right in the
ISPLAY
"half steps". When the partial gets below -10 or above
10 partials, the decrement/increment is in steps of 1
partial instead of 0.5 partials
switches to show the frequency in Hz.
ISPLAY
knob the pitch will increment or
OARSE
will increment or decrement and show the cor-
ISPLAY
When the frequency exceeds 1000
LED D
Hz, the
indicate the frequency in kHz with a
dot indicating the 'k' figure.
is the partial value
ISPLAY
will in-
ISPLAY
knob
INE
indicates the partial
switches to
ISPLAY
Page 69