Rtp/Rtsp - Cisco PVC2300 Administration Manual

Configuring the PVC2300 and WVC2300 Cameras
Setup > Advance Setup
Cisco PVC2300 and WVC2300 Internet Video Cameras with Audio Administration Guide
When using a secure connection, video is not available. This option is used
only for configuration.
The port number must be specified in the URL when accessing the
camera's web-based utility via the LAN or Internet. For example, if the
camera's IP address is 192. 1 68. 1 .99 and the port is defined as 1032, you
would specify the following address: https://192. 1 68. 1 .99:1032.

RTP/RTSP

RTSP (Real Time Streaming Protocol) is a standard for connected client(s) to
control streaming data (MPEG-4) over the Internet.
RTP (Real-Time Transport Protocol) is an Internet protocol used for transmitting
single real-time multimedia data such as audio and video to a select group of
connected clients. RTSP uses RTP to format packets of multimedia content.
• RTSP Port—Enter the RTSP Port number (between 1024 to 65535) in the
field provided. The default RTSP port is 554.
• RTP Data Port—The camera's data port number has been pre-configured
and can be used for multicasting. It does not normally need to be re-
configured. If a port number does need to be changed, please contact your
network administrator. If a change is necessary, enter the data port number
(1024 to 65535) in the field provided. The default RTP port is 5000.
• Max RTP Data Packet—Allows you to define the maximum size of the RTP
data packets. The length can be between 400 to 1400 bytes. The default
value is 1400 bytes.
• Enable Multicast—The camera's video and audio IP addresses have been
pre-configured and can be used for multicasting. Normally these settings
do not need to be reconfigured. If an address does need to be changed,
contact your network administrator.
8
69