Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Button Remotes - Chamberlain Security+ 257856 Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
remote control to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚

To Add or Reprogram a Hand-held Remote Control

USING THE "LEARN" BUTTON
1. Press and release the "learn" button
on the motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and hold
the button on the hand-held remote*
that you wish to operate your
garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
® garage door opener is operated with a non-rolling code remote control, the technical measure
USING THE MOTION DETECTING DOOR CONTROL
CONSOLE
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button,
press and hold the LIGHT button on
the Motion Detecting Door Control
Console.
3. Continue holding both buttons while
you press the push bar on the
Motion Detecting Door Control
Console (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code.
If light bulbs are not installed, two
clicks will be heard.

*3-Button Remotes

If provided with your garage door
opener, the large button is
factory programmed to
operate it. Additional buttons
on any Security✚ ® 3-button
remote or mini-remote can
be programmed to operate
other Security✚ ® garage
door openers.
37
® remote controls.