Cat.5 or Cat.5e network cable The power outlet should be within 1.82 meters (6 feet) of the switch Visually inspect the DC power jack to make sure that it is securely connected to the power adapter Make sure that there is proper heat dissipation and adequate ventilation around...
2. Hardware Installation 1. Connect the Power Adapter to the TE100-S5/TE100-S8 and then to a power outlet. 2. Connect a Cat.5 or Cat.5e RJ-45 network cable from the computer to an available Ethernet port on the TE100-S5/TE100-S8.
3. LEDs Power Green: Power is on Not Illuminated: Power is off Link/ACT Green (Solid): Connection for the port is 100/200(half/full) or 10/20(half/full) Green (Blinking): Activity is occurring Not Illuminated: No activity is detected...
IEEE 802. 3 10Base-T Standard IEEE 802.3u 100Base-TX IEEE 802.3x Flow Control Ethernet: Cat. 5 up to 100m Network Media Fast Ethernet: Cat. 5, 5e, 6 up to 100m Ethernet: 10Mbps/20Mbps (Half/Full-Duplex) Data Rates Fast Ethernet: 100Mbps/200Mbps (Half/Full-Duplex) Switch Fabric 1.0Gbps Forwarding Capacity 1.6Gbps Forwarding Capacity...
Internet router such as the TW100-S4W1CA. 4. Where is the uplink port located on the Switch? Since all the ports on the Switch are Auto-MDIX, any of the ports can be used as an uplink port.
Page 8
If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty continues from the original date of purchase.
Page 9
THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE. Governing Law: This Limited Warranty shall be governed by the laws of the state of California. Some TRENDnet products include software code written by third party developers. These codes are subject to the GNU General Public License ("GPL") or GNU Lesser General Public License...