Download Print this page
TRENDnet TE100-PCIE User Manual
TRENDnet TE100-PCIE User Manual

TRENDnet TE100-PCIE User Manual

Fast ethernet card 10/100mbps pci bus
Hide thumbs Also See for TE100-PCIE:

Advertisement

Quick Links

Product Specifications
Standards
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
PCI Local Bus specification
Rev. 2.0
System Clock
Up to 33Mhz
Data Bus Width
32-bit bus mastering PCI
I/O Address
Automatically determined by
configuration space
IRQ Line
INTA, being assigned by the
BIOS to a free I/O address
Full Duplex
10/20Mbps, 100/200Mbps
Interface
One RJ-45, autoconfiguration
for 100Base-TX/10Base-T
Dimension
130mm x 57mm
LED indicators
Link-10Mbps, Link-100Mbps
Activity
Certifications
FCC Class A, CE
ODI drivers
Novell NetWare 3.x 4.x,
NetWare LAN WorkPlace,
Novell LAN Analyzer
Packet drivers
FTP PC/TCP, NCSA TCP/IP
NDIS 2.0 drivers
Microsoft LAN Manager,
Windows for Workgroups,
DEC PATHWORKS,
Sun PC-NFS, Banyan VINES
NDIS 3.0 drivers
WFW 3.11, Windows 95,
Windows NT 4.0.
5
TE100-PCIE
FAST ETHERNET CARD
10/
100Mbps PCI bus
B
M
US
ASTERING
F
D
ULL
UPLEX
P
P
LUG
LAY
AND
U
G
SER'S
UIDE

Advertisement

loading

Summary of Contents for TRENDnet TE100-PCIE

  • Page 1 Data Bus Width 32-bit bus mastering PCI I/O Address Automatically determined by 100Mbps PCI bus configuration space IRQ Line INTA, being assigned by the BIOS to a free I/O address ASTERING Full Duplex 10/20Mbps, 100/200Mbps Interface One RJ-45, autoconfiguration UPLEX for 100Base-TX/10Base-T...
  • Page 2 FCC Compliance Statement Table of Contents This equipment has been tested and found to comply with the limits for class A device, pursuant to Part INTRODUCTION 15 of FCC rules. These limits are designed to ..........provide reasonable protection. This equipment...
  • Page 3 Category 3, 4 or 5 for 10Mbps mode and category 5 for 100Mbps mode The adapter supports full-duplex mode. Full duplex LED indicators for installation verification and mode can be used to obtain throughput of up to diagnostic purpose. 20/200Mbps when connecting through an Ethernet switching hub.
  • Page 4: Installation

    Hardware Installation Before you connect adapter to the network, you have to install the network driver first. The driver Turn OFF the computer, unplug the power cord for each networking operating system is under a and open the computer case.