Advertisement
Quick Links
Installation Instructions
Reference Enthalpy
Foundation™ Packaged Rooftop Units
15 to 25 Tons
Model Number:
BAYENTH305*
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of
heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are
attached to the equipment.
September 2024
Used With:
E/GDK180-300
ACC-SVN309A-EN
SAFETY WARNING
Advertisement
Related Manuals for Trane Foundation BAYENTH305 Series
Summary of Contents for Trane Foundation BAYENTH305 Series
- Page 1 Installation Instructions Reference Enthalpy Foundation™ Packaged Rooftop Units 15 to 25 Tons Model Number: Used With: BAYENTH305* E/GDK180-300 SAFETY WARNING Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
-
Page 2: Warnings, Cautions, And Notices
When working with or around hazardous chemicals, these compounds have the same potential impact to the ALWAYS refer to the appropriate SDS and OSHA/GHS environment. Trane advocates the responsible handling of all (Global Harmonized System of Classification and refrigerants. Labeling of Chemicals) guidelines for information on... - Page 3 Copyright This document and the information in it are the property of Trane, and may not be used or reproduced in whole or in part without written permission. Trane reserves the right to revise this publication at any time, and to make changes to its content without obligation to notify any person of such revision or change.
-
Page 4: General Information
General Information Inspection 1. Unpack all components of the kit. 2. Check carefully for shipping damage. If any damage is found, report it immediately, and file a claim against the transportation company. Parts List Table 1. Parts list Description Humidity Sensor Control Harness Wire Tie Installed Accessory Label... -
Page 5: Installation
Installation UC unit configuration will need to be updated to reflected WARNING installed option. Hazardous Voltage w/Capacitors! Figure 2. Fresh air options module location Failure to disconnect power and discharge capacitors before servicing could result in death or serious injury. Disconnect all electric power, including remote disconnects and discharge all motor start/run capacitors before servicing. - Page 6 Installation Figure 4. Sensor location for standard economizer Bushing OAH Sensor Figure 5. Sensor location low leak economizer Bushing OAH Sensor ACC-SVN309A-EN...
- Page 7 Notes ACC-SVN309A-EN...
- Page 8 For more information, please visit trane.com or americanstandardair.com. Trane and American Standard have a policy of continuous product and product data improvement and reserve the right to change design and specifications without notice. We are committed to using environmentally conscious print practices.
Need help?
Do you have a question about the Foundation BAYENTH305 Series and is the answer not in the manual?
Questions and answers