Install The Software; Sending A Data Or Fax Call - Motorola V70 User Manual

Attaching a Serial Cable
Use the interchangeable head on the Motorola Multi-Connect Serial Cable to
connect a computer, Palm III device, or Palm V device to your phone.
Do This
Plug the serial cable into the detachable head. Make sure that the Motorola
1
logo on the detachable head and the metal shielding on the serial cable plug
are both facing you.
2 With the Motorola logo and the phone both facing you, plug the detachable
head into your phone's accessory connector port.
3 Plug the other end of the cable into the serial interface connection on the
external device and tighten the screws.
Attaching a USB Cable
Do This
1 Plug the end of the cable with the Motorola logo into your phone's accessory
connector port. Make sure that the logo and the phone are both facing you.
2 Plug the other end - the USB connection - into the USB port on the external
device.

Install the Software

Install the software from the CD-ROM that comes with your Motorola Original
data kit. See the data kit's user guide for more information.

Sending a Data or Fax Call

You can connect your phone to a computer or hand-held device to send data or a
fax from the connected device.
Use this feature to transfer data from your computer onto another device, and to
synchronise phonebook and datebook information between your phone,
computer, and/or hand-held device.
Connect your phone (see "Connecting Your Phone to an External Device" and do
the following:
Do This
1 Check the phone
2 Open the application on your
computer
End the transfer on your computer close the call and connection when the
3
116 Data and Fax Calls
To
make sure that the phone is connected
and powered on.
place the call through the application
(such as dial-up-networking or fax).
You cannot dial data or fax numbers
A
through your phone's keypad. You
must dial them through your
computer.
transfer is complete.