Cleaning And Maintenance - Sencor SVC 1010 User Manual

Vacuum Cleaner
SVC 1010/ 1011BL / 1011GR (Forte)
Ending the vacuuming process
When you finish vacuuming, switch the vacuum cleaner off by pressing the START / STOP button and then
disconnect the supply cable plug from the socket.
To wind the power cord back to the vacuum cleaner, press and hold the winding button with one hand. Hold the
cord with your other hand to protect the vacuum cleaner input area from damage.
MN. Tip:
Q If the winding process stops and part of the power cord is still outside, release the winding button and pull
the cable out again by about 50cm and press the winding button again and repeat the winding process.
=
Carrying your vacuum cleaner
If you need to carry the vacuum cleaner, hold it only by the handle.
Caution:
Never try to carry your vacuum cleaner by holding the dust container handle!
STORAGE OF VACUUM CLEANER
Before storage you can disassemble your appliance to each individual part or you can store it assembled with the
telescopic tube stored in one of the parking positions.
CLEANING AND MAINTENANCE
Caution:
Before cleaning disconnect this product from the power source.
Emptying the dust container
Empty the dust container as soon as the full container warning light comes on; otherwise the air flow and the
suction strength will be reduced.
Safety lock of the bottom
hatch
Plastic conical filter
Bottom hatch
Copyright O 2012, Fast CR, a.s. Revision 05/2012